2002 CHEVROLET TRACKER 4DR SUV
Security
Battery WHT/YEL (+) IGNITION HARNESS
Ignition BLK/WHT (+) IGNITION HARNESS
Starter01 BLK/RED OR (+) BLK/YEL IGNITION HARNESS
AllDoorTrigger BLK/RED (-) PASS SIDE PIN SWITCH
TrunkTrigger BLK/RED SHARED WITH DOOR CIRCUIT
ParkingLights RED/YEL (+) AT PARKING LIGHT RELAY IN DASH
Remote Start
Battery WHT/YEL (+) IGNITION HARNESS
Ignition BLK/WHT (+) IGNITION HARNESS
Ignition02 +
Ignition03 +
Accessory01 YEL/BLK + (+) IGNITION HARNESS
Accessory02 +
Starter01 BLK/RED OR (+) BLK/YEL IGNITION HARNESS
AntiTheftSystem NONE
KeySense LT GRN (-) - (-) AT SWITCH HARNESS
Tach BRN(-) (-) AT ECM BELLOW GLOVE COMPARTMENT
SpeedSense YEL (AC) LEFT OF STEERING YEL 22 PIN CONN POS 7
ParkingLights RED/YEL (+) AT PARKING LIGHT RELAY IN DASH
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
ReverseLights LT GRN (+) + (+) IGNITION HARNESS
Horn GRN/BLU (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/BLK + (-) DRIVERS KICK PANEL
PowerLock PNK + (-) DRIVERS KICK PANEL
LeftFrontWindow01 BLU REV
LeftFrontWindow02 BRN REV AT SWITCH IN DOOR
RightFrontWindow01 BLU OR BLU/WHT REV AT SWITCH IN DOOR
RightFrontWindow02 TAN REV AT SWITCH IN DOOR
Convenience
HeadLights RED (-) AT LIGHT SWITCH HARNESS
Mobile Audio / Video
Battery WHT/YEL (+) IGNITION HARNESS
Accessory01 YEL/BLK + (+) IGNITION HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination RED/YEL (+) RADIO HARNESS
Dimmer RED/GRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos WHT
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos BLU
FrontRightSpeakerNeg WHITE/RED
RearLeftSpeakerPos LT.GRN
RearLeftSpeakerNeg LT.GRN/BLK
RearRightSpeakerPos GRY
RearRightSpeakerNeg GRY/BLK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
